AEG SCS51800F0 User Manual page 41

Problem
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
Water flows on the
ground.
The temperature in
the appliance is too
low/high.
The temperature in
the refrigerator is
too high.
The temperature in
the freezer is too
high.
There is too much
frost.
6.1 Replacing the lamp
1
6.2 Closing the door
1. Clean the door gaskets.
Downloaded from Fridge-Manual.com Manuals
Possible cause
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water
collector.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The temperature regula-
tor is not set correctly.
There is no cold air circu-
lation in the appliance.
Products are too near to
each other.
Food is not wrapped cor-
rectly.
The door is not closed
correctly.
The temperature regula-
tor is not set correctly.
2
Solution
This is correct.
Clean the water outlet.
Make sure that products
do not touch the rear
plate.
Attach the melting water
outlet to the evaporative
tray.
Set a higher/lower temper-
ature.
Make sure that there is
cold air circulation in the
appliance.
Store products so that
there is cold air circulation.
Wrap the food correctly.
Refer to "Closing the
door".
Set a higher temperature.
1. Switch off the appliance.
2. Press on the rear hook and at the
same time slide the cover in the di-
rection of the arrow.
3. Replace the lamp with one of the
same power and specifically de-
signed for household appliances.
(the maximum power is shown on
the lamp cover).
4.
Slide the lamp cover into its original
position.
5. Switch on the appliance.
6. Open the door. Make sure that the
light comes on.
2. If necessary, adjust the door. Refer
to "Installation".
ENGLISH
41