Table of Contents
Advertisement
detection area, sensitivity, alarm output port, alarm delay time, alarm handling, linkage
video channel, PTZ linkage, video delay time, etc. according to the video channel.
The system can obtain network IPC's arm and disarm time, alarm delay time, sensitivity,
detection area as well as video detection enable switch status. Here are the remote settings
for the network IPC:
Arm / Disarm time period: according to customer needs, you can set four arming
periods during the day. Each time period cannot be crossed, and cannot set the time period
across the days. Only in the arming time, all set take effect on video detection.
Alarm output ports: according to customer needs, specify the output port of a video
detection, this output can be output to a separate way, would also have multiple outputs.
According to the actual situation of the back-end alarm output device, the alarm output
switch can be set to normally open / normally closed.
Video detection zone: You can specify an area in need of detection range, use the
46
UMD NVR User Manual
Advertisement
Table of Contents
