Rear Panel - Toshiba D-RW2SU Owner's Manual

Rear Panel

11
1. ANTENNA IN jack
Use to connect an antenna.
2. VIDEO IN jack (LINE1)
Use to connect external equipment with a standard
video cable.
3. VIDEO OUT jack
Use to connect a TV monitor, AV receiver or other
equipment with a standard video cable.
4. AC Power Cord
Connect to a standard AC outlet to supply power to
this unit.
5. COAXIAL DIGITAL AUDIO OUTPUT jack
Use to connect an AV receiver, Dolby Digital
decoder, DTS decoder or other equipment with a
coaxial digital input jack with a digital coaxial cable.
6. AUDIO OUT jacks
Use to connect a TV monitor, AV receiver or other
equipment with a standard audio cable.
Notes
• Do not touch the inner pins of the jacks on the rear panel. Electrostatic discharge may cause permanent damage to the
unit.
• This unit does not have the RF modulator.
Downloaded From Disc-Player.com Toshiba Manuals
Introduction_UD.indd 15 Introduction_UD.indd 15
1 2 3
COMPONENT
VIDEO IN
VIDEO OUTPUT
VIDEO OUT
IN
S-VIDEO
Y
IN OUT
L L
OUT
P /C
B B
R
R
ANTENNA P /C
AUDIO IN R R
AUDIO OUT
(L1)
10 9 8 7 6
4
DIGITAL AUDIO OUTPUT
PCM / BITSTREAM
COAXIAL
5
7. COMPONENT VIDEO OUTPUT jacks
Use to connect a TV monitor with component video
inputs with a component video cable.
8. S-VIDEO OUT jack
Use to connect the S-Video input of a TV monitor,
AV receiver or other equipment with an S-Video
cable.
9. S-VIDEO IN jack (LINE1)
Use to connect the S-Video output of external
equipment with an S-Video cable.
10. AUDIO IN jacks (LINE1)
Use to connect external equipment with a standard
audio cable.
11. ANTENNA OUT jack
Use to connect an antenna cable to pass the signal
from the TV ANTENNA IN to your TV monitor.
EN 15
2006/01/11 16:26:47 2006/01/11 16:26:47