Dirt Devil HAND VAC Owner's Manual
Hide thumbs Also See for HAND VAC:

Advertisement

HAND VAC
Owner's Manual
P l e a s e
read these instructions
c a r e f u l l y b e f o r e
using your
Hand Vac.
L e t us
help you put your
v a c u u m
together
or
answer
any questions,
call:
1-800-321 -1 134 (USA & Canada)
CONSUMER INFORMATION
T H l S VACUUM IS INTENDED FOR HOUSEHOLD USE ONLY.
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic precautions should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING THlS APPLIANCE.
l
ALWAYS FOLLOW THESE SAFETY INSTRUCTIONS.
l
WARNING: THE CORDS, WIRES AND/OR CABLES SUPPLIED WITH THlS PRODUCT CONTAINS CHEMICALS,
INCLUDING LEAD OR LEAD COMPOUNDS, KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER AND
BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM. WASH HANDS AFTER USING.
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY:
Do not leave appliance when plugged in. Unplug from outlet when not in use and before servicing.
l
Do not use outdoors or on wet surfaces.
Do not allow to be used as a toy. Close attention is necessary when used by or near children.
l
Use only as described in this manual. Use only manufacturer's recommended attachments.
l
Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped
into water, return it to a service center.
l
Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do not run appli-
ance over cord. Keep cord away from heated surfaces.
Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
l
Do not handle plug or appliance with wet hands.
Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair and anything that may reduce air flow.
Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
l
Turn off all controls before unplugging.
l
Use extra care when cleaning on stairs.
l
Do not use to pick up flammable or combustible liquids such as gasoline or use in areas where they may be present.
Look on your vacuum cleaner and follow all label and marking instructions.
l
Do not use an extension cord with this cleaner.
Keep end of hose, wands and other openings away from your face and body. Keep your hands, feet, hair and clothing away from moving
parts; especially the revolving brush.
l
Do not use the vacuum cleaner without dustbaa or filters in place.
l
Store the vacuum cleaner indoors. Put the vacuum cleaner away after use to prevent tripping accidents.
SAVE THESE INSTRUCTIONS
Approved
by
the Vacuum Cl e aner Manufacturer' s Association Executi v e Commi t tee, April
29,1987.
WARNING
To reduce the risk of electric shock, this appliance has a polarized plug (one blade wider than the other). This plug will fit in a polarized
outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to
install the proper outlet. Do not change the plug in any way.
This vacuum cleaner will operate best when serviced with genuine parts. To besure that you receive genuine parts and service at fair prices,
have your cleaner serviced at an Authorized Royal' Dealer or see your Yellow Pages for a dealer near you. Should you experience any dif-
ficulties in operating this vacuum cleaner, report it immediately to the dealer from whom it was purchased. Costs of any transportation to and
from any place of repair are to be paid by the owner. The service parts used in this unit are easily replaced and readily available from your
Authorized Royal" Dealer.
NOTE: RETURN WARRANTY CARD TO REGISTER YOUR CLEANER.
Your cleaner contains a Thermal Protector which will automatically shut off the motor at abnormally high motor temperatures. If the Thermal
Protector is activated
-
switch off and unplug the cleaner. Contact an authorized service represenative or call customer Service at 1-800-321 -1 134.
0 1995 All Rights Reserved.
#
1-500181-001
Rev. 1 1/02

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HAND VAC and is the answer not in the manual?

Questions and answers

Paulette Mabry
May 5, 2025

My Dirt Devil hand vac is making a very loud noise when turned on.

1 comments:
Mr. Anderson
May 18, 2025

A loud noise from your Dirt Devil hand vac when turned on could be caused by a problem with the motor, especially since it hasn't been used in years. Possible causes include:

1. Worn motor bearings or brushes.
2. Dirt or debris inside the motor.
3. Lack of lubrication in moving parts.
4. Loose or damaged internal components.

Given that the rest of the unit is in good shape, the noise likely comes from internal motor wear or damage.

This answer is automatically generated

Karen
February 3, 2025

Can I get a replacement cloth bag for the model 500?

1 comments:
Mr. Anderson
May 14, 2025

Yes, you can find a replacement cloth bag for the Dirt Devil model 500 hand vac. The manual mentions that the cloth bag can be removed, washed, and reused. If a replacement is needed, compatible cloth bags like those from EnviroCare are available.

This answer is automatically generated

Ed
January 20, 2025

What style belt for model #103

1 comments:
Mr. Anderson
February 4, 2025

The compatible belt style for the Dirt Devil model #103 is Prince Style 1.

This answer is automatically generated

CATHY SHILLING
January 18, 2025

How do you get the belt around the brush roller?

1 comments:
Mr. Anderson
May 14, 2025

To install the belt around the brush roller on a Dirt Devil Hand Vac:

1. Remove the bottom plate by taking out the two Phillips screws.
2. Take out the metal nozzle guard.
3. Pull the brush and belt assembly straight out from the center of the brushroll.
4. Place the new belt around the brushroll.
5. Make sure the arrows on the brushroll and nozzle guard point in the same direction.
6. Reinsert the brushroll and belt assembly.
7. Use a flathead screwdriver to stretch the belt over the motor pulley.
8. Ensure the belt is aligned correctly and the brushroll rotates properly.
9. Reattach the nozzle guard and bottom plate with the screws.

This answer is automatically generated

Table of Contents

Save PDF