Husqvarna TR530 Instruction Manual page 23

6
5
4
2
1
Inset A
Inset B
12
13
14
15
16
17
1. Outer side shield
2. Nut "A"
3. Nut "B"
4. Drive control bar
5. Handle
6. Throttle control
7. Fuel Valve
8. Starter handle
9. Shift lever in di ca tor
10. Depth stake
Fig ure 10
8
7
3
9
10
11
Figure 11
Inset C
18
19
11. Depth Stake pin
12. Transport po si tion
13. Shallowest till ing
14. Shallow tilling
15. Deep tilling
16. Deepest tilling
17. Depth stake
18. "Release" po si tion
19. "Lock" position
Reverse
a. Release the drive control bar (fig. 10).
b. Move throttle control (fig. 10) to slow Position
c. Place shift lever indicator (fig. 11 -inset A) in the "R"
(reverse) position.
d. Do not stand directly behind tiller.
e. Hold the drive control bar against the handle (fig. 10) to
start tiller movement. Tines will not turn.
WARNING!
Don't back yourself into a solid obstruction such as a tree,
fence, etc.
Stopping tines and engine
a. Tiller movement and tines will stop when drive control
bar (fig. 10) is released.
b. Move shift lever indicator (fig. 11 -inset A) to "N" (Neutral)
position.
c. To stop engine, move throttle control (fig. 10) to slow
position and allow the engine to run at low speed for 1
or 2 minutes before moving throttle to stop position.
d. Close the fuel valve (fig. 10).
e. Pull the starter handle (fig. 10) slowly and return the
handle to its original position when reistance is felt. This
operation is necessary to prevent outside moist air from
intruding into the combustion chamber.
Turning
a. Release the drive control bar (fig. 10).
b. Move throttle control (fig. 10) to "SLOW" po si tion.
c. Place shift lever indicator (fig. 11 - inset A) in "F" (forward)
position. Tines will not turn.
d. Lift handle to raise tines out of the ground (fig. 10)
e. Swing the handle in the opposite direction you wish to
turn, being careful to keep feet and legs away from the
tines.
When you have completed your turn-around, lower the handle.
Place shift lever in di ca tor in ( ) (tilling) position and move
throttle control to desired speed. To begin tilling, hold drive
control bar against the handle.
Outer side shields
The back of the outer side shields (fig. 10) are slotted so that
they can be raised for deep tilling and lowered for shallow
tilling to protect small plants from being buried. Loosen nut
"A" in slot and nut "B". Move shield to desired position (both
sides). Retighten nuts.
Transporting
a. Lower the depth stake to its lowest position and insert
the depth stake pin in the topmost hole.
b. Place shift lever indicator (fig. 11 inset A) in "F" (foward)
position for transporting.
c. Hold the drive control bar against the handle (fig. 10) to
start tiller movement. Tines will not turn.
d. Move throttle control (fig. 10) to desired speed.
23
3