Door Adjustment - Sunbeam 20060328 Service Manual

Adjust the door with the key included in the refrigerator until the magnetic gasket touches the cabinet uniformly and
the door is lined up with the cabinet edges. See figure 1.
1. Dismount the refrigerator's door.
2. Place the door on a table so that the paint is not damaged.
3. Lift the gasket in one of the corners.
4. Pull the basket backwards to let it loose from the plastic counter gate and do the same operation in the whole
gasket contour until it is completely out.
5. Once the gasket is out, clean the door foam residues.
6. Take a new gasket and in one of the corners break the internal gasket appendix with a sharp knife and pull until it is
completely loose.
7. Mount the gasket, lift the counter gate gently, and adjust the contour parallel to the door upper part.
8. Puncture the counter gate in the points indicated.
9. Perforate the door with self – threaded screws type AB #8-18 x ½.
10. Clean the door and gasket with water and mount the door again in the refrigerator.

Door adjustment

FIGURE 1
Door gasket replacement
PAGE. A5