Table of Contents
Advertisement
2-6. CONNECTING WIRES FOR INDOOR UNIT
process the end of the wire.
8) Secure indoor/outdoor unit connecting wire (A) and the earth wire with the cord
Indoor/outdoor unit
connecting wire (A)
15 mm
35 mm
• For future servicing, give extra length to the connecting wires.
Electrical cover
Cord clamp
Fixing screw
Earth wire
Indoor/outdoor unit
connecting wire (A)
2-7. PIPE FORMING AND INSTALLATION
Pipe Forming
the hose.
-
Connecting Pipe Installation
left, and right.
• Be sure to insulate the connecting pipes and place them near the rear of the indoor
-
Band (5)
Bundle the connecting pipes and drain hose together, and then wrap them in felt tape (11).
Cut and use the lower side panels on the left and right sides of the indoor unit as shown
ing.
• For left or right piping
pipes and hose are routed from the indoor unit. (The overlap width of the felt tape (11)
is not routed upward.
Felt tape (11)
piping
Piping
tape
Push
Drain hose
Pipe cover (4)
cover.
Molding
Cut the lower side panels to match the
height of the molding.
around the pipes and hose 10 mm
inside the indoor unit.
Fasten the end of the felt tape (11) with
Band (5)
-
Advertisement
Table of Contents
