Ir Sensor; Batteries; Cleaning - Philips 7600 series User Manual

When you started the initial TV installation, the TV
invited you to press the OK key, and by doing so,
the pairing was done. When you switch off the TV, the
pairing is stored. You can pair up to 5 remote controls
with this TV.
Pairing Again
You can pair another remote control with this TV.
The method to pair a remote control is different for a
remote control already paired with another TV
compared with a remote control that is not paired yet.
• The remote control is paired with another TV
To pair, hold the remote control close to the Philips
logo (about 10cm) and press the

and Blue key at the same time. A message will
appear if pairing is successful.
• The remote control is not paired yet
To pair, hold the remote control close to the Philips
logo (about 10cm) and press OK. A message will
appear if pairing is successful.
Retail
To pair a new — not yet paired — TV with a remote
control which is already paired with another TV, hold
the remote control close to the Philips logo (about

10cm) and press the
same time.
A message will appear if pairing was successful.
6.4

IR Sensor

The remote control of the TV uses RF (radio
frequency) to send its commands to the TV. With RF,
you do not need to point the remote control at the
TV.
However, the TV can also receive commands from a
remote control that uses IR (infrared) to send
commands. If you use such a remote control, always
make sure you point the remote control at the
infrared sensor on the front of the TV.

Red

Red and Blue key at the
6.5

Batteries

The TV will notify you when the battery power of the
remote control is low.
To replace the batteries, open the battery
compartment on the keyboard side of the remote
control.
1 - Use a small coin or other small, blunt object and
press the rectangular shaped release button to open
the battery lid.
2 - Slide the battery in the direction of the metal
spring and pull the opposite end of the battery out.
3 - Replace the old batteries with 2
type AA-LR6-1.5V alkaline batteries. Make sure the
+ and the - ends of the batteries line up correctly.
4 - Reposition the battery door and push it down
until it clicks.
Remove the batteries if you are not using the remote
control for a long time.
Safely dispose of your old batteries according to the
end of use directions.
For more information, press
up End of use.
6.6

Cleaning

Your remote control is treated with a scratch-resistant
coating.
To clean the remote control, use a soft damp cloth.
Never use substances such as alcohol, chemicals or
household cleaners on the remote control.
27

Keywords and look