Advertisement
Microphone transmitter(s)
Power on / off / standby switch
Low battery indicator LED - when continuously lit you have approximately one hour left of useful operation. Ideally
change the battery when lit.
Battery cover & AAA alkaline batteries - provide power to the microphone transmitter. Typical battery life is 20
hours. IMPORTANT: use alkaline batteries only, carbon-zinc and zinc-chloride batteries will not provide adequate
power and are not recommended.
Channel select switch panel - remove this cover to access the channel selection dip switches (see below for
channel selection instructions).
Using the KWM1935 wireless receiver
1.
Connect output to your mixer/amplifier, using either a balanced XLR cable or an unbalanced, single conductor
1/4 inch jack plug cable.
2.
Connect the AC adapter to the receiver and plug into an appropriate power outlet.
Using the KWM1940 wireless receiver
1.
Connect outputs for channel A & B to your mixer/amplifier, either two balanced XLR cables for dual output or
a single unbalanced 1/4 inch jack plug cable for mixed output of both channels.
2.
Connect the AC adapter to the receiver and plug into an appropriate power outlet.
Using the wireless microphone transmitter(s)
1.
Slide the mic ON/OFF/STANDBY switch to the ON position.
2.
Check the signal indicator is lit on your receiver to see if the radio signal is being received.
3.
If the signal indicator is lit, begin singing or speaking.
4.
During the performance, slide the ON/OFF/STANDBY switch to the STANDBY position when the mic is not
being used.
5.
When the performance is over, slide the ON/OFF/STANDBY switch to the OFF position to conserve battery
power.
Setting the frequency selection system
It is important to ensure that the transmitter(s) and receiver are set to operate using the same basic frequency.
There are 16 channels available and each channel has a specific frequency factory assigned to it. Both the
KWM1935 & KWM1940 use the same 16 frequencies. The table below shows the 16 different channels, the
frequencies assigned to those channels and the various DIP switch settings used to choose a particular channel.
Set the transmitter channel
1.
Open the channel select switch panel.
2.
Choose a channel you wish to use.
3.
Set the DIP switch according to the channel/frequency table.
When using the KWM1940 you will need to choose and set different channels for each transmitter when using both
microphones.
Set the receiver channel
KWM1935
1.
Open the channel select switch panel.
2.
Choose a channel you wish to use.
3.
Set the DIP switch according to the channel/frequency table.
KWM1940
1.
Open the channel select switch panel.
2.
Choose the channels you wish to use.
3.
Set the DIP switches for channels A & B according to the channel/frequency table.
Advertisement
