Specifications - Makita 6904VH Instruction Manual

ENGLISH (Original instructions)
1-1. Switch trigger
2-1. Reversing switch
3-1. Reversing switch

SPECIFICATIONS

Capacities
No load speed (min
Impacts per minute
Max. fastening torque
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for fastening bolts and nuts.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Model 6904VH
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Model 6905H
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Explanation of general view
4-1. Speed change lever
5-1. Socket
5-2. Anvil
Model
Standard bolt
High tensile bolt
Wood screw
Self-drilling screw
Square drive
-1
)
Overall length
Net weight
Safety class
) : 95 dB(A)
pA
) : 106 dB(A)
WA
) : 94 dB(A)
pA
) : 105 dB(A)
WA
6904VH
M10 - M16
M10 - M12
6 mm x 100 mm
6 mm
12.7 mm
High: 0 - 2,400
Low: 0 - 2,100
High: 0 - 3,000
Low: 0 - 2,500
High: 196 N.m
Low: 147 N.m
265 mm
1.8 kg
ENE036-1
Vibration
The vibration total value (tri-axial vector sum) determined
ENF002-2
according to EN60745:
Model 6904VH
Work mode : impact tightening of fasteners of the
maximum capacity of the tool
Vibration emission (a
Uncertainty (K) : 1.5 m/s
ENG905-1
Model 6905H
Work mode : impact tightening of fasteners of the
maximum capacity of the tool
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
3
6-1. Socket
6-2. O-ring
6-3. Pin
/II
) : 6.5 m/s
h
2
) : 6.0 m/s
h
2
6905H
M12 - M20
M12 - M16
-
-
12.7 mm
2,200
-
2,600
-
294 N.m
-
275 mm
2.3 kg
/II
ENG900-1
2
2
ENG901-1