2. Check that the Chart screen has the Radar Overlay turned On. If not,
3. Select the Radar pane so that it becomes the active pane. If you can't
4. Select Adjust Radar, then select Installation.
5. The Bearing Alignment button shows the current setting. Select
6. Select OK to confirm the new setting.
7. When you are finished, select Return.
150
turn it on (see "Overlay the radar" in Chart).
see the Adjust Radar button, select Return.
the button if you want to change the setting, then use the Up and
Down buttons or the rotary knob to move the radar image one
degree at a time, until the radar overlay is aligned with the chart.
Northstar 8000i Operation Manual