IBM THINKPAD L460 Hardware Maintenance Manual page 89

• "1050 Base cover assembly" on page 70
Removal steps of the speaker assembly
Step Screw (quantity)
3
M2 × 4 mm, big head, nylon-coated (4)
When installing:
• Ensure that the speaker rubbers are well installed.
• Ensure that the connector of the speaker assembly is attached firmly.
• Route the cables as shown in the following illustration.
Attention: As you route the cables, ensure that they are not subject to any tension. Tension could cause
the cables to be damaged by the cable guides, or a wire to be broken.
2
2
2
2
8
1
Color
Black
.
Chapter 9 Removing or replacing a FRU
Torque
0.181 Nm
(1.85 kgf-cm)
83