Error Messages - IBM THINKPAD L460 Hardware Maintenance Manual

Table 2. Numeric error codes (continued)
Symptom or error
0199
System Security— Security password retry count
exceeded.
1802
Unauthorized network card is plugged in—Turn off and
remove the network card.
1820
More than one external fingerprint reader is attached.
Power off and remove all but the reader that you set up
within your main operating system.
2000
ThinkVantage Active Protection sensor diagnostics failed.
2100
Detection error on HDD0 (Main HDD)
2101
Detection error on SSD1 (M.2)
2102
Detection error on SSD2 (M.2)
2110
Read error on HDD0 (Main HDD)
2111
Read error on SSD1 (M.2)
2112
Read error on SSD2 (M.2)
2200
Machine Type and Serial Number are invalid.
2201
Machine UUID is invalid

Error messages

Table 3. Error messages
Symptom or error
Fan error.
Thermal sensing error.
36
ThinkPad L460 Hardware Maintenance Manual
FRU or action, in sequence
1. Run the ThinkPad Setup program. The retry count
will be reset. Then save the current settings by
pressing F10.
2. Replace the system board.
1. Remove network card.
2. Replace the system board.
Remove all but the reader that you set up for the
authentication.
Have the computer serviced.
1. Reseat the hard disk drive.
2. Replace the main hard disk drive.
3. Replace the system board.
1. Reseat the M.2 solid-state drive.
2. Replace the solid-state drive.
3. Replace the system board.
1. Reseat the M.2 solid-state drive.
2. Replace the solid-state drive.
3. Replace the system board.
1. Reseat the hard disk drive.
2. Replace the main hard disk drive.
3. Replace the system board.
1. Reseat the M.2 solid-state drive.
2. Replace the solid-state drive.
3. Replace the system board.
1. Reseat the M.2 solid-state drive.
2. Replace the solid-state drive.
3. Replace the system board.
Replace the system board.
Replace the system board.
FRU or action, in sequence
1. Replace the thermal fan assembly.
2. Apply thermal grease.
3. Replace the system board.
Replace the system board.