Samsung SW12E1S(P)/XST Service Manual page 18

4-3 After Servicing
1) First, select the installing location.
• Set the direction of the drain hose according to the con-
dition of the place.
• Keep the washer the minimum 10 cm away from the
wall.
2) Level checking
• Adjust so that the bubble of the level indicator is in the
center of the circle.
How to adjust the level
Bubble
Cause
Positio
Lower front
Lower rear
Lower left
Lower right
3) Leveling
• If not level, adjust the leveling feet so that the washer is
level.
• Be cautious not to put the hand under the leveling feet.
(It may cause to hurt the hand.)
* If not level, it may cause the severe vibration or a
failure.
Be sure to be level.
a. Pull the adjusting handle of the
left, right leveling feet on the
front to the front and push them
to the left or right.
b. Adjust the washer upward or
downward to be level.
18
Adjustment
Adjust the leveling feet.
Adjust by putting the level-
ing rubber or a stand at the
rear.
Adjust the left side by
adjusting the leveling feet
on the front or putting the
leveling rubber at the rear.
Adjust by putting the leveling
rubber or a stand at the rear.
Loosening
c. When the adjustment is done,
pull the adjusting handle to the
front again to fix the leveling
feet.
4) Properly arrange the wire bundle at the bottom so that it is
not stretched even if the tub-ass'y leans. (If not, it may cause
vibration or noise during the spin.)
5) While reassembling the top-cover after being separated,
ensure that the air-hose is not caught between the out-case
and the top-cover. (It may cause the occurrence of 'No drain'
or 'No water supply' error.)
Caution
* While separating or assembling the top-cover, the power-
cord wire on the rear side may come out of the top-cover. It
may cause the occurrence of a problem caused by nicking
of wire while assembling the cover-TC. Therefore, ensure
that the wire does not come out of the top-cover before start-
ing assembling.
SAMSUNG WASHING MACHINE
Fixing