Starting Up The Device; Care And Maintenance; Technical Data - Weller WTSF 80 Original Instructions Manual

Starting up the device

Caution!
Please be sure to read and follow the opera-
ting instructions for your Weller Supply Unit.

Care and maintenance

Warning!
Before doing any work on the machi-
ne, pull the plug out of the socket.
Warning!
Use original replacement parts only.
Warning! Risk of burns
Only replace solder tips when cold
„

Technical Data

Solder wire feed system
Power supply unit
Input
Output
Rated input
Mains supply voltage
Weight
Safety class
Safety class Feed unit
Temperature range
Heat-up time (approx.) in
seconds
(50°C to 380°C) (120°F to 660°F)
Tip top condition
Put the tool into operation as described in the
chapter „Placing into operation".
Check to see if the mains voltage matches the
ratings on the nameplate.
Only replace the soldering tips when they are cold.
The soldering tool must be left switched off in the
safety rest for at least 3 minutes until the soldering
tip has cooled down. The LED status indicator
must be at „OFF".
Keep the heat transfer surfaces of the soldering tip
and heating element clean. The heating element
must not come into contact with soldering tin.
Clean the operator panel, if dirty, using a suitable
cleaning cloth.
WTSF 80
~
100 - 240 V 50-60 Hz
12 V 1500 mA
86 W
24 V AC
approx. 1 kg
I
III
Celsius: 100 - 450°C
Fahrenheit: 200 - 850°F
10
LT
WTSF 120 / WXSF 120
~
100 - 240 V 50-60 Hz
12 V 1500 mA
126 W
24 V AC
approx. 1 kg
I
III
Celsius: 100 - 450°C
Fahrenheit: 200 - 850°F
14
XT
23