Table of Contents
Advertisement
TROUBLESHOOTING
RESET
If your buds are not responding, connect the charging
clip and USB cable to a power source. This will turn
your buds off and perform a soft reset.
FACTORY RESET
1. To reset your buds to their original factory
settings put your buds in pairing mode by turning
the buds off then push and hold
center button for more than 4 sec until you see
alternating red/green LED.
2. While the LED is flashing red / green
double tap
successful factory reset, the LED turns
orange and your buds turns off.
NOTE: Once your buds have been reset and you
power on they will automatically go into pairing mode.
Select "Forget" or "Remove" Jaybird Freedom from
your device's Bluetooth menu and pair again.
38
the center button. Upon
the
LED
Hide quick links:
Advertisement
Table of Contents
