Table of Contents
Advertisement
1
010372
Adjust the edge fence until it comes in contact with the
side of the workpiece, then secure it by tightening the
screw.
010333
When planing, move the tool with the edge fence flush
with the side of the workpiece. Otherwise uneven planing
may result.
Maximum shiplapping (rabbeting) depth is 9 mm.
010183
You may wish to add to the length of the fence by
attaching an extra piece of wood. Convenient holes are
provided in the fence for this purpose, and also for
attaching an extension guide (optional accessory).
Chamfering
003634
1. Screw
2. Edge fence
(Accessory)
2
010184
To make a chamfering cut as shown in the figure, align
the "V" groove in the front base with the edge of the
workpiece and plane it.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
Sharpening the planer blades
For conventional blades only
002588
Always keep your blades sharp for the best performance
possible. Use the sharpening holder (optional accessory)
to remove nicks and produce a fine edge.
1
2
3
002589
First, loosen the two wing nuts on the holder and insert
the blades (A) and (B), so that they contact the sides (C)
and (D). Then tighten the wing nuts.
9
1. Sharpening
holder
1
1. Wing nut
2. Blade (A)
3. Blade (B)
4. Side (D)
5. Side (C)
5
4
Advertisement
Table of Contents
