Deactivate Lamp Monitoring Failure - Mercedes-Benz Sprinter 2016 Handbook

Sprinter 906

Deactivate Lamp Monitoring Failure

Details & Technology
This code deactivates the monitoring of the vehicle's exterior lighting system.
Benefits
• Makes it possible for aftermarket lamps to be fitted to the vehicle
Provided that the maximum lamp load is not exceeded, it is possible to connect further lamps
to the vehicle's electrical system without the indicator lamp in the instrument cluster lighting
up and an error being incorrectly recorded in the SAM control unit memory.
Body builders can fit lamps which are needed for the specific body.
License plate light:
Backup light:
Turn signal:
Fog light:
Tail light:
When using LED's, a resistor must be used to compensate for the lower AMP draw. Turn
Signal LED's AMP draw is recommended to be between 1.75A – 1.96A (max 2.1Amp)
otherwise rapid flashing will occur.
Please consult the Body Builder Information Book for further information.
Benefits
Standard on Chassis Cab.
1.0A
2.4A
1.75A -1.96A (max 2.1Amp)
N/A (tape back)
1.0A
©2015 Mercedes-Benz USA, LLC / Daimler Vans USA, LLC
JW2
200