Table of Contents
Advertisement
Sprinter 906
EK1
Body Builder Connector under Driver Seat
Details & Technology
Additional electrical components must be connected using the auxiliary electrical connector
(EK1) standard from the factory (max 25 A). The electrical connector is installed inside the
driver's seat base (at the front, on the left-hand side of the vehicle) and has three terminals:
Terminal 1: 12 V/10 A (120 W) Power engine running (Blue/Yellow)
Terminal 2: 12 V/25 A (300 W) Battery direct power (Red/Grey)
Terminal 3: 12 V/15 A (180 W) Ignition power (Black/Yellow)
Note:
Maximum load is 25 A. Electrical loads greater than 25A requires the Auxiliary Battery
package PY1 (E28).
Benefits
The terminal strip allows easy integration of additional electrical consumers into the existing
power network. The blank switch panel allows the integration of additional switches for the
operation of body/conversion systems installed by body manufacturers or vehicle operators.
Remarks
EK1 is standard on all models.
©2015 Mercedes-Benz USA, LLC / Daimler Vans USA, LLC
119
Advertisement
Table of Contents
