Fujitsu STYLISTIC Q736 Operating Manual page 122

Appendix
Methods for accessing the utilities
Recovery and Utility Tools are preinstalled in a hidden partition by the factory, or
they can be accessed by using the bootable disc.
Note: The Recovery and Utility tools may be deleted from your hard disk drive if you modify the
partitions. If that occurs, you will not be able to use the hidden partition for booting to Recovery
and Utility Tools, but you will still be able to boot from the Bootable Disc.
Determining whether Recovery and Utility is pre-loaded
1. Turn on or reboot your system. When the Fujitsu logo appears, press the
2. Use the key to get to the Application Menu.
Tab
3. Check whether the Recovery and Utility option is present. If it is not present, it means that
the utility must be used from the Bootable Disc. Proceed to the ""Running Recovery and
Utility from the Bootable Disc""section if Recovery and Utility is unavailable.
Running Recovery and Utility from hard disk
1. Turn on or reboot your system. When the Fujitsu logo appears, press the
2. Use the key to get to the Application Menu.
Tab
3. Move the cursor down to Recovery and Utility and press the
4. Choose your language, if necessary. Select Recovery and Utility to proceed.
5. Three tool options appear: Diagnostics, Recovery, and Utility (refer to the" Recovery and
Utility tools "section below for instructions on how to use these tools).
6. If this was successful please skip the next step and go to the "Recovery and Utility tools" section.
7. If this was NOT successful, please go to the next step.
Running Recovery and Utility from the Bootable Disc
Note: If your system does not have an internal writable DVD drive, connect
your system to an external drive.
To verify/change the boot-up priority (rather than booting-up from the hard drive or
an external media drive), perform the following steps:
1. Power on your system. When the Fujitsu logo appears on the screen, press the
2. Insert the bootable disc into the drive tray.
3. Highlight the CD/DVD option from the Boot menu, then press
4. Click OK.
5. Select CD/DVD boot mode: UEFI Mode, if applicable then press
files are being loaded from the disc, the Fujitsu logo screen will appear followed
by a progress bar at the bottom of the screen.
Recovery and Utility tools
Note: Recovery and Utility tools may not be available on your system depending
on the region from which the system was shipped.
Diagnostics tool: The Diagnostics tool is designed for use by IT professionals. It is not likely you
will need to use this tool. If you should need to use this tool, perform the following steps:
1. Press the Diagnostics Toolbutton to start the Diagnostics tool.
2. Read the note, and then click OK.
120
F12 key.
F12 key.
Enter key.
F12
.
Enter
Enter . While the
key.
Fujitsu