Axis Q1602-E Installation Manual page 10

Page 10
Attach camera to the wall bracket
1. Loosen the cable cover screws; detach the cable cover from the bottom cover.
2. Place the camera with the bottom cover on the wall bracket and tighten the bracket screws.
3. Remove the gasket from one of the cable holes in the bottom cover; see illustration on page 11.
4. Route the network cable through the cable hole and fix the cable gasket in the cable hole.
5. Replace the cable cover and tighten the screws.
6. Connect the cables. See
7. Loosen the bracket adjustment screw to focus the camera; focus the camera according to the
instructions under
for information on how to view the video stream.
8. Attach the safety wire in the top cover to the tab in the bottom cover (see image under
Hardware overview
9. Attach the top cover to the bottom cover. Make sure to tighten diagonally opposite bottom
cover screws a few turns at a time until all are tight. Do not tighten screws completely the first
time.
10. Loosen the sunshield adjustment screws and adjust the sunshield to the desired position.
11. Optionally insert an SD memory card (not included) into the SDHC (Secure Digital High
Capacity) card slot. A standard or high capacity SD card is required to store images locally in
the camera.
Connect the cables,
Adjust zoom and focus,
).
AXIS Q1602-E/AXIS Q1604-E Installation Guide
Network cable (routed
through wall bracket)
Cable holes
Bracket screw (4x)
Cable cover
Cable cover screw (2x)
Wall bracket
Bracket adjustment screw
on page 11.
Access the video stream,
on page 17. See
Bottom cover
on page 16