Wagan ProLine 2007-2 User Manual page 4

ProLine 3,000W Power Inverter by Wagan Tech
™
readout to the next readout. The lit/unlit status of two green LEDs show which function is being
shown on the Digital Display
The display and button are used to help diagnose problems if they occur.
Green LEDs Status (Shows Display Mode,
LEFT LED
Volts Readout – Digital Display (left LED unlit, right LED Lit)
The volts display is the measurement of the voltage at the DC terminals of the inverter, not
actual battery voltage. During high wattage applications the display may show a lower
voltage level than the battery because of a voltage drop that can occur between the DC
input cables and the battery. This voltage drop should not be greater than 0.25 to 0.5
volts, as a greater voltage will seriously reduce run time. This inverter will operate with the
following input voltage range, varying by model:
#2007-2 — 10V-15V DC Input
#2007-4 — 20V-30V DC Input
#2007-8 — 40V-60V DC Input
The inverter is equipped with an alarm and shut down feature based on these changes in
input voltage:
Feature:
Alarm sounds when input
voltage drops below:
Inverter shuts down when
input voltage drops below:
Inverter shuts down when
input voltage rises above:
During charging from a generator, solar panel or AC powered charger the battery voltage
will be higher than when it is resting. Voltages greater than allowed may cause damage to
the inverter. Damage caused by excessive voltage input is not covered under the warranty.
Amps Readout – Digital Display (left LED lit, right LED unlit)
This readout indicates actual DC amperes of current being drawn from the battery bank.
Note that for a 120 amp reading the inverter should be powering 1,200 watts of AC load.
3
RIGHT LED DISPLAY Mode
DC Input Voltage
DC Input Current (Amps)
AC Output Wattage (Kilowatts)
Diagnostic Codes (E01, E02, E03, E04)
#2007-2 (12V)
10.5V ± 0.5V DC
10.0V ± 0.5V DC
>15.0V DC
www.wagan.com
®
= Lit, = Unlit)
#2007-4 (24V)
21.0V ± 1.0V DC
20.0V ± 1.0V DC
>30.0V DC
#2007-8 (48V)
42.0V ± 2.0V DC
40.0V ± 2.0V DC
>60.0V DC