Ec Declaration Of Conformity; Maintenance - Makita 6823 Instruction Manual

Operation
Fit the screw on the point of the bit and place the
point of the screw on the surface of the workpiece to
be fastened. Apply presssure to the tool and start it.
Withdraw the tool as soon as the clutch cuts in. Then
release the trigger.
CAUTION:
• When fitting the screw onto the point of the bit, be
careful not to push in on the screw. If the screw is
pushed in, the clutch will engage and the screw will
rotate suddenly. This could damage a workpeice or
cause an injury.
• Make sure that the bit is inserted straight in the
screw head, or the screw and/or bit may be dam-
aged.
Hook (Fig. 9 & 10)
The hook is convenient for temporarily hanging the
tool. When using the hook, pull it out in "A" direction
and then push it in B direction to secure in place.
When not using the hook, return it back to its initial
position by following the above procedures in
reverse.
How to install and remove the Removable
Cord Adapter
Important:
Always be sure that the tool is switched off and
unplugged before removing or installing the Remov-
able Cord Adapter
How to install
Insert the Removable Cord Adapter as far as it goes
so that the marking
Cord Adapter on the side of connecting to power sup-
ply cord is aligned to the marking
end of the Removable Cord Adapter on the side of
connecting to the tool. (Fig. 11)
Turn the Removable Cord Adapter clockwise until it is
locked with a lock button. (Fig. 12)
And at this time the marking
Removable Cord Adapter on the side of power supply
cord is aligned to the marking
the Removable Cord Adapter on the side of connect-
ing to the tool. (Fig. 13)
How to remove
Rotate the Removable Cord Adapter counterclock-
wise until it stops while pressing the lower part of the
lock button. (Fig. 14)
Then pull the Removable Cord Adapter in that posi-
tion. (Fig. 15)

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
To maintain product safety and reliability, repairs,
maintenance or adjustment should be carried out by
a Makita Authorized Service Center.
on an end of the Removable
on the other
on an end of the
on the other end of
For European countries only
Noise and Vibration
The typical A-weighted sound pressure level is 80 dB (A).
Uncertainty is 3 dB (A).
The noise level under working may exceed 85 dB (A).
– Wear ear protection. –
The typical weighted root mean square acceleration
value is not more than 2.5 m/s
These values have been obtained according to
EN60745.
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this product
is in compliance with the following standards of standard-
ized documents,
EN60745, EN55014, EN61000
in accordance with Council Directives, 73/23/EEC, 89/
336/EEC and 98/37/EC.
Yasuhiko Kanzaki
MAKITA INTERNATIONAL EUROPE LTD.
Michigan Drive, Tongwell, Milton Keynes,
Bucks MK15 8JD, ENGLAND
Responsible manufacturer:
Makita Corporation Anjo Aichi Japan
2
.
CE 2005
Director
ENG003-2
ENH101-4
7