Returning To The Cli; Text Conventions - Nortel NN46200-301 Installation Manual

10 Preface

Returning to the CLI

The config.cfg file for the CLI and the config.cfg file for the NNCLI are not
compatible. If you decide to change the CLI mode to NNCLI, or the reverse,
you must use the config.cfg file for the selected mode.
To switch from the NNCLI to the CLI, enter the following commands:
ERS-8310:5(config)# no boot flags nncli
ERS-8310:5(config)# exit
ERS-8310:5(config)# save boot
You must reboot the switch for this change to take effect.

Text conventions

This guide uses the following text conventions:
angle brackets (< >)
bold body text
bold Courier text
braces ({})
Copyright © 2007, Nortel Networks
.
Password: nortel
ERS-8310:5# configure terminal
ERS-8310:5(config)#
Nortel Ethernet Routing Switch 8300
Installation — AC Power Supply
NN46200-301 03.01 Standard
4.0 27 August 2007
Indicate that you choose the text to enter based on
the description inside the brackets. Do not type the
brackets when entering the command.
Example: If the command syntax is
ping <ip_address>, you enter
ping 192.32.10.12
Indicates objects such as window names, dialog box
names, and icons, as well as user interface objects
such as buttons, tabs, and menu items.
Indicates command names, options, and text that
you must enter.
Example: Use the dinfo command.
Example: Enter show ip {alerts|routes}.
Indicate required elements in syntax descriptions
where there is more than one option. You must
choose only one of the options. Do not type the
braces when entering the command.
Example: If the command syntax is
show ip {alerts|routes}, you must enter
either
show ip alerts or show ip routes, but not
both.