Top Panel; Side Panels; Power Connection; Power Button - Alesis DM7X User Manual

TOP PANEL

1. OUTPUTS – Use standard 1/4" TRS cables
to connect these outputs to a speaker or
amplifier system. The level of these outputs
is controlled by the VOLUME knob.
2. AUX IN – Use a standard 1/8" stereo cable
to connect this input to an optional audio
player (e.g,. MP3 player, CD player, etc.).
This audio will be heard in the OUTPUTS
and PHONES output. During recording, the
audio from this input will not be recorded.
3. TOM 4 INPUT – Use a standard 1/4" TRS cable to connect this input to an optional drum pad, which
will trigger the Tom 4 sound.
4. CRASH 2 INPUT – Use a standard 1/4" TS cable to connect this input to an optional cymbal pad, which
will trigger the Crash 2 sound.
5. MIDI OUT – Use a standard five-pin MIDI cable to connect this output to the MIDI IN of an external
MIDI device.
6. MIDI IN – Use a standard five-pin MIDI cable to connect this input to the MIDI OUT of an external MIDI
device.
7. USB – This connection will allow you to send MIDI information to a computer. Use a USB cable (sold
separately) to connect the module to an available USB port on your computer.
Note: Only MIDI information is sent over the USB connection, not audio.

SIDE PANELS

1. POWER CONNECTION – Connect
the included power adapter (9V DC,
500mA, center pin-positive) here,
then connect the adapter to wall
power.
2. POWER BUTTON – Press this
button to turn the module on. Press
and hold it for a second then release
it to power the module off.
3. PHONES – Connect a set of 1/8"
stereo headphones to this output.
7
5 6
3
5
3 4 1 1 2
1
2