Haier HL42XK1 Service Manual page 16

E x t e r n a l E q u i p m e n t
NOTE: All cables shown are not included with the TV.
Choose Y our Connection
There are several ways to connect your television,
depending on the components you want to connect and
the quality of the signal you want to achieve. The
following are examples of some different ways to connect
your TV with different input sources.
Connecting a
VCR
To avoid picture noise (interference), leave an adequate
distance between the VCR and TV.
Connection Option 1
Set VCR output switch to channel 3 or 4 and then tune
the TV to the same channel number.
Connection Option 2
1. Connect the audio and video cables from the VCR's
output jacks to the TV input jacks, as shown in the figure.
When connecting the TV to VCR, match the jack colors
(Video = yellow, Audio Left = white, and Audio Right = red).
If you connect a S-VIDEO output from VCR to the
S-VIDEO input, the picture quality is improved;
compared to connecting a regular VCR to the Video input.
2. Insert a video tape into the VCR and press PLAY on
the VCR. (Refer to the VCR owner`s manual.)
3. Select the input source with using the
INPUT button on the remote control, and
then press / button to select the source,
press ENTER button to confirm.
C o n n e c t i o n s
2
1
Y Pb Pr L R
AUDIO AUDIO
1
VIDEO VIDEO L AUDIO AUDIO R S-VIDEO S-VIDEO L AUDIO AUDIO
2
L
DVI AUDIO DVI AUDIO
1
R
VGA AUDIO VGA AUDIO VGA
R VIDEO VIDEO L AUDIO R