Removing A Password - Acer 310 User Manual

310-e.book Page 90 Tuesday, October 27, 1998 5:17 PM
Setup Utility
The password box appears:
2. Type a password. The password may consist of up to
seven characters (A-Z, a-z, 0-9).
Important: Be very careful when typing your
password because the characters do not appear on
the screen.
3. Press Enter. Retype the password to verify your first
entry and press Enter.
After setting the password, the computer automatically
sets the chosen password parameter to Enabled.
4. Press Esc to go to the Exit menu.
5. Press Save Change & Exit to save the password and
exit the Setup Utility.
To change a password, follow the same steps used to set a
password.

Removing a Password

Should you want to remove a password, do the following:
1. Use the
parameter (Supervisor or User) and press the Enter key.
The password box appears:
2. Enter your current password in the first parameter and
then press Enter.
3. Press Enter twice without entering anything in the next
two password box to remove the existing password.
4. Press Esc to go to the Exit menu.
90
and keys to highlight a Set Password
User's Guide