Advertisement
(9) BANK/BUFFER display
When press the BANK switch, i
When a program is recalled by press PGM1/PGM2, it shows the buffer setup for 2 seconds,
then it turns to show the current bank number.
(10) INPUT
Connect guitar here.
(11) SEND jack of loop
Connect this jack to input of guitar pedal.
(12) OUTPUT
Connect the jack to amplifier or other instruments.
(13) LOCK
The programmer buttons will be disabled when the toggle switch is at the lock position.
(14) RETURN
Connect this jack to output of guitar pedal.
(15) TUNER
This jack internally connects to input jack when MUTE switch is engaged, normally it
connects to a tuner.
(16) 9V DC
5.5x2.1mm type, connects to
2- Signal Chain
Output
"3"
could be
loop1
or loop2
or loop3
or thru
SARAMANDRA Tail Loop allows to change the connection order of guitar pedals.
Guitar signal is fed to the input jack, goes into BJF buffer circuit, then it is posted
to loop stations 1"
loop2 or loop3 or thru, each loop can only be used once in the loop stations.
t shows the bank number.
negative center
loop stations
"2"
could be
loop1
or loop2
or loop3
or thru
"
"2" "3" in sequence, each loop station could be set to loop1 or
DC
9V/300mA power supply.
"1"
could be
loop1
or loop2
or loop3
or thru
3
BJF buffer
Input
on/off
Advertisement
