Advertisement
1- Overview
Top Panel
7
8
9
3
1
2
(1) PGM1/PGM2
The two footswitches recall program 1/program 2 stored in the memory.
Press again on a recalled program will master bypass the switcher.
(2) Programmer buttons
These are programmer buttons, 1", 2", 3 are to edit the order of the loops,
"1" "2" "3" represent the positions in the signal chain,
"
BUF
" is to on/off the BJF buffer circuit. Check the detail in the programmer section.
(3) PGM indicator
Program indicator, it lights up when a program is recalled.
(4) LOOP display
The display show the connection order of active loops.
(5) BANK switch
The switch scrolls up the bank number by short pressing, or hold this switch for 2s
to change the memory lane (see section 6).
(6) BJF buffer indicator
The indicator lights up when the BJF buffer is on.
(7) MUTE indicator
The indicator lights up when the switcher is muted.
(8) MUTE switch
The switch mutes the output, at the same time connects "Input" jack to "Tuner" jack.
6
16
5
4
3
"
"
" "
2
Rear Panel
14
15
10
13
12
11
Advertisement
