Operating Instructions - Bosch Vision 300 Operating, Care And Installation Instructions Manual

OPERATING INSTRUCTIONS

Before using
,
WARNING
Panel
A Cycle Selector
Switches the machine on and off and
selects the program (see page 23). Can
be turned in both directions.
To switch off the dryer, rotate
the cycle selector to Off".
B
LED Indicator Lights
LED'S light up in sequence to show the
current moisture state of the drying
process.
Wrinkle BlockR/Finished - at the
end of the drying cycle an acoustic
signal sounds and the Wrinkle
BlockR/Finished LED lights up. The
drum rotates at specific intervals for
one hour to prevent the laundry from
creasing (see page 24 ).
C Lint Filter LED
Blinks as a reminder to clean the lint
filter after use. Blinks for 10 seconds
when the door is opened after a cycle
ends, or in the event airflow is reduced
enough to create a CLn" or E:12"
error (see troubleshooting guide, page
31).
,
A
D Display
300 and 500 Series
LED countdown indicates the estimated remaining
time of a running cycle (in minutes).
800 Series
Indicates the settings of additional options and the
estimated remaining time of programs. (See page 26)
Additional Options
Menu selects one of the additional options
Select changes the settings of the selected option
E
Option buttons
Add functions to the cycle selected. The option button
LED is lit when the option is selected. Press the option
button again to turn the option off (LED turns off).
Delicates: Press for temperature-sensitive textiles
(e.g. acrylic fibers). The temperature of the drying
process is reduced, the drying time is extended
correspondingly.
ECOAction: Press for additional energy savings (use
only for cotton and permanent press cycles). Press the
option button prior to starting an automatic cycle.
WARNING
B D
C
E
G
F
F Signal
300 and 500 Series
Press both option buttons at the same time
to enable the acoustic signal. When the
cycle is finished, an audible beeping tone
will be emitted (see page 23). Press both
buttons again to disable the signal.
800 Series
The 800 Series signal is set using the LCD
menu (see page 26).
G
Start/Pause Button
Starts, interrupts and ends the drying
process.
Start/Pause LED Status
Lit Red: Program is running and "Pause"
can be activated.
Blinking: Settings can be changed, the
drying cycle can be started, or program is
in Pause" mode.
Not Lit: Cycle is finished or there is no
cycle selected.
21