Table of Contents
Advertisement
2. SEQUENCE SET - This submenu allows you to select how long
NOTE : Channels without a camera, a Video Loss, or a Dwell
Time of zero will be skipped in sequencing.
3. TITLE SET - This submenu allows you to change the title of each
camera location (up to 8 characters), or remove the
titles from the on-screen display.
(i) DISPLAY : Selecting [Y] will enable the camera titles to appear
in the on-screen display. Selecting [N] will remove
all titles from appearing in the on-screen display.
(ii) CH 1 - 8 : Change the titles of each individual camera.
4. ALARM SET - This submenu allows you to enable / disable the camera's PIR Alarm function by channel.
(i) ALARM : Selecting [OFF] disables PIR motion detection from triggering any alarm. Selecting [OSD] will
allow alarms to be triggered, and the letters "AL" will appear on the screen of the camera location where
the alarm is taking place. A third option, [OSD+BUZZER] will both display "AL" and emit a buzzer sound
in the event of an alarm.
(ii) CH 1-8 : Set the length of alarm time for each channel between 1~59 seconds. Additionally, you can
select the Alarm Input. The default setting is ON - to activate the Alarm on a camera make sure the
alarm set is "ON" by selecting OSD or OSD + BUZZER, change the contact setting to a N/O (Normally
Open) or a N/C (Normally Closed) depending on the type of contact used.
Note: Some alternative brand PIR motion sensors have a default setting of N.C (normally closed). In order
to activate the alarm on such a PIR motion sensor, change the setting to N.C
5. MOTION SET - This submenu allows you to enable / disable the Pixel-based Motion Detection function by
channel and set its Sensitivity level.
(i) MOTION : Selecting [OFF] disables the Pixel-based Motion Detection function. Selecting [OSD] will
allow motion to trigger alarms, and the letters "MD" will appear on the screen of the camera
location where the motion is taking place. A third option, [OSD+BUZZER] will display "MD"
and emit a buzzer sound in the event that motion is detected.
(ii) CHANNEL : Select which channels will have the Pixel Motion Sensing feature activated. The Sensitivity
level can be set to zero for a channel, which will disable the Motion Sensing ability for that
channel.
you'd like each channel to appear on-screen
before automatically switching to the next
channel in Sequence mode. The Dwell Time
is 0-59 seconds selectable for each of the 8
channels and for Quad mode.
[SEQUENCE SET]
QUAD
: [03 SEC]
CH 1
: [03 SEC]
CH 2
: [03 SEC]
CH 3
: [03 SEC]
CH 4
: [03 SEC]
CH 5
: [03 SEC]
CH 6
: [03 SEC]
CH 7
: [03 SEC]
CH 8
: [03 SEC]
RETURN
: [
]
EXIT
: [ ]
[TITLE SET]
DISPLAY
: [Y]
CH 1
: [CAMERA01]
CH 2
: [
C2
CH 3
: [
C3
CH 4
: [
C4
CH 5
: [
C5
CH 6
: [
C6
CH 7
: [
C7
CH 8
: [
C8
RETURN
: [ ]
EXIT
: [ ]
]
]
]
]
]
]
]
-9-
Advertisement
Table of Contents
