Bosch GWS Professional 18-125 V-LI Original Instructions Manual page 20

OBJ_BUCH-1102-006.book Page 21 Thursday, June 5, 2014 1:02 PM
Removing the battery
The battery 5 is equipped with two locking levels that should
prevent the battery from falling out when pushing the battery
unlocking button 6 unintentionally. As long as the battery is
inserted in the power tool, it is held in position by means of a
spring.
To remove the battery 5, press the unlocking button 6 and
pull out the battery toward the front. Do not exert any force.
Battery Charge-control Indication (see figure A)
The three green LEDs of the battery charge-control indicator
24 indicate the charge condition of the battery 5. For safety
reasons, it is only possible to check the status of the charge
condition when the machine is at a standstill.
Press button 23 to indicate the charge condition. This is also
possible when the battery 5 is removed.
LED
Continuous lighting 3 x green
Continuous lighting 2 x green
Continuous lighting 1 x green
Flashing light 1 x green
When no LED lights up after pushing button 23, then the bat-
tery is defective and must be replaced.
Mounting the Protective Devices
 Before any work on the machine itself (e. g. mainte-
nance, tool change, etc.) as well as during transport
and storage, remove the battery from the power tool.
There is danger of injury when unintentionally actuating
the On/Off switch.
Note: After breakage of the grinding disc during operation or
damage to the holding fixtures on the protection guard/power
tool, the machine must promptly be sent to an after-sales ser-
vice agent for maintenance. For addresses, see section "Af-
ter-sales Service and Application Service".
Bosch Power Tools
Protection Guard for Grinding
 Adjust the protection guard 10 in such a manner that
sparking is prevented in the direction of the operator.
Note: The encoding keys on the protection guard 10 ensure
that only a protection guard that fits the machine type can be
mounted.
Protection Guard for Cutting
 For cutting with bonded abrasives, always use the pro-
tection guard for cutting 16.
 Provide for sufficient dust extraction when cutting
stone.
Capacity
The protection guard for cutting 16 is mounted in the same
≥2/3
manner as the protection guard for grinding 10.
≥1/3
Cutting Guide with Dust Extraction Protection Guard
<1/3
The cutting guide with dust extraction protection guard 26 is
Reserve
mounted in the same manner as the protection guard for
grinding 10.
Auxiliary Handle
 Operate your machine only with the auxiliary handle 7.
Screw the auxiliary handle 7 on the right or left of the machine
head depending on the working method.
Hand Guard
 For operations with the rubber sanding plate 19 or with
the cup brush/wheel brush/flap disc, always mount the
hand guard 18.
The hand guard 18 is fastened with the auxiliary handle 7.
Mounting the Grinding Tools
 Before any work on the machine itself (e. g. mainte-
nance, tool change, etc.) as well as during transport
and storage, remove the battery from the power tool.
There is danger of injury when unintentionally actuating
the On/Off switch.
 Do not touch grinding and cutting discs before they
have cooled down. The discs can become very hot while
working.
Clean the grinder spindle 8 and all parts to be mounted.
For clamping and loosening the grinding tools, lock the grind-
er spindle with the spindle lock button 2.
English | 21
Place the protection guard 10 on
the spindle collar. Adjust the posi-
tion of the protection guard 10 to
the requirements of the operation.
Lock the protection guard 10 tight-
ening the locking screw 9 with a hex
key 4.
1 609 92A 0N2 | (5.6.14)