Mitsubishi Electric PUHZ-SHW80VHA Service Manual page 89

1 1 - 1 - 3. S elec ting func tions using th e wireless remote c ontroller ( T y p e C )
[ F low of func tion selec tion p roc edure]
CHECK
ON/ OFF TEMP
ON/ OFF button
FAN
MODE
V ANE
CHECK LOUV ER
Check button
TEST RUN
SET RESET CLOCK
[ O p erating instruc tions]
1
CHECK
2
h
3
4
5
6 4 5
7 3 5
8
OCH526C
F low of func tion selec tion p roc edure
The flow of the function selection procedure is shown below. This ex a mple shows how to turn
off the function that raises the set temperature by 4 degrees during HEAT operation.
The procedure is given after the flow chart.
1 Check the function selection setting.
2 Switch to function selection mode.
(Enter address "50" in troubleshooting
mode, then press the HOUR button.)
3 Specify unit No. "01" (since the function applies to unit 01).
(Set address "01" while still in troubleshooting mode, then press the MINUTE button.)
Note: Y ou cannot specify the refrigerant address.
AUTO STOP
4 Select mode No. "24" (function that raises set temperature by 4 degrees during HEAT operation).
(Set address "24" while still in troubleshooting mode, then press the HOUR button.)
AUTO START
5 Select setting No. "02" (OFF).
h
HOUR button
(Set address "02" while still in troubleshooting mode, then press the HOUR button.)
min
MINUTE button
8 End function selection mode.
(End troubleshooting mode.)
min
Troubleshooting mode is the mode entered when
you press the CHECK button twice to display
"CHECK".
NO
Finished
Y ES
Note: When you switch to function selection mode
on the wireless remote controller' s operation
area, the unit ends function selection mode
automatically if nothing is input for 10 minutes
or longer.
6
min
h
h
7
Y ES
Change
unit No.
NO