NordicTrack ViewPoint NTL14905.0 User Manual page 10

8. Remove the Shock Pin (108) from the lower end of the
Shock (114).
Plug in the power cord as described on page 13, and
then turn on the power as described on page 15. Next,
press the Incline increase and decrease buttons until the
ball on the bracket is aligned with end of the Shock
(114). Then, press the end of the Shock onto the ball.
Note: It may be necessary to press the end of the Shock
onto the ball while the Frame (55) is moving.
See drawing 8a. Insert the end of the Shock Pin (108)
into two of the small holes in the end of the Shock (114).
Then, rotate the Shock Pin until it clips onto the Shock.
Press the Incline decrease button until the treadmill is at
the lowest incline level. Unplug the power cord. With the
help of a second person, lower the Frame (55) to the floor.
9. Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen
wrench in a secure place; the allen wrench is used to adjust the walking belt (see page 35). To protect the
floor or carpet from damage, place a mat under the treadmill.
8
85
108
8a
Bracket
10
55
114
Bracket
108 114