Zanussi ZDK320 User Manual page 11

eg. automatic line protecting cut-out, earth leakage
trips or fuse.
• None of a parts of the connection cable can not get a
temperature 90 °C. The blue neutral cable must be
connected to the terminal block label with "N". The
brown (or black) phase cable (fitted in the terminal
block contact marked with "L") must always be connec-
ted to the live phase.
Replacement of the connection cable
To replace the connection cable use only H05V2V2-F T90
or equivalent type. Make sure that the cable section is ap-
plicable to the voltage and the working temperature. The
yellow/green earth wire must be approximately 2 cm lon-
ger than the brown (or black) phase wire.
Assembly
min. 650 mm
If several 30 cm hobs are to be installed side by side into
the same cut out, an assembly kit including a support side
bracket and supplementary seals is available at our Serv-
ice Centres. The relevant installation instructions are sup-
plied within the kit package.
A — seal to remove
B — supplied brackets
Possibilities for insertion
Kitchen unit with door
The panel installed below the hob must be easy to remove
and let an easy access in case a technical assistance inter-
vention is necessary.
a) Removable panel
b) Space for connections
Kitchen unit with oven
490 mm
The hob recess dimensions must obey the indication and
the kitchen unit must be equipped with vents to let a con-
tinuous supply of air. The electrical connection of the hob
270 mm
and the oven must be installed separately for safety rea-
sons and to let easy remove oven from the unit.
A
MANUFACTURER:
B
ELECTROLUX ITALIA S.p.A.
C.so Lino Zanussi, 30
33080 PORCIA (PN) - ITALIA
30 mm
a
min 20 mm
60 mm
(max 150 mm)
b
2
50 cm
2
360 cm
2
120 cm
180 cm 2
11