The Bottom Side; The Right Side; Using The Interface Ports; Battery Charging Via Usb Connector - Bones Milestone 212 Ace User Manual

1.1.3. The bottom side

The headphone socket is located on the bottom side of the device. When connected,
audio is output directly through the headphones, instead of the internal speaker.
Your Milestone 212 Ace memorizes separate volume levels for speaker and headphones.

1.1.4. The right side

The SD memory card slot is located on the right side of the device. The Milestone 212
Ace's internal memory capacity of 2.5 GB can be expanded with SD cards of up to 32 GB.

1.2. Using the interface ports

The following section describes the four interface ports of the Milestone 212 Ace - the
microphone socket, headphone jack, USB connector and the SD card slot.

1.2.1. Battery charging via USB connector

Connect the charger provided with your Milestone 212 Ace to a power outlet. Plug the
other end of the charger cable into the mini-USB-socket, located at the center of the
Milestone's top side.
The connection was successfully established, once you hear a low beep and the LED light
on the user interface starts flashing every 3 seconds. The device will be fully charged after
3 hours.
Please note that a connection to a computer via USB-cable also recharges the battery, as
long as the computer remains powered on. You can check the battery's charging status by
using the Milestone 212 Ace's „Information Service" function, described under chapter 2.6
of this manual.
Milestone 212 Ace comes with a powerful, rechargeable lithium polymer battery.
After fully charging the battery, it allows for continuous operation of up to 20 hours and a
standby time of several weeks.
Battery life is affected by speaker volume and reading speed.
In order to maximize playback time, you may want to listen to music and books over the
headphones, at medium volume and use standard reading speed for books.
Please note that using the internal speaker of your Milestone 212 Ace, listening at high
volume and faster reading rates, requires more energy and therefore reduces the overall
playback time.

1.2.2. Headphones

If you prefer to use headphones with your Milestone 212 Ace, rather than the built-in
speaker, simply plug in any standard headphones with a 3.5 mm jack into the socket
located at the bottom side of the Milestone.
Please note that your Milestone memorizes two separate volume levels. One for its
internal speaker and another for connected headphones.
2
/17