Listening To A Recorded Voice Message; Deleting Voice Messages; The 5 Recording Folders; Changing Between The Folders - Bones Milestone 212 Ace User Manual

If you wish to pause the recording for a moment, you can press the "Play" button. Press
"Play" again to continue the recording.

4.3. Listening to a recorded voice message

To listen to a voice message, press "Play" when you're done recording. You can choose
between your recorded voice messages by using the arrow buttons.
Hint: You can jump to the last recorded voice message by holding down the "Right arrow"
button and pressing "Play". To skip to the first recorded file, keep the "Left arrow" button
pressed and then push "Play".

4.4. Deleting voice messages

You can delete voice messages on your Milestone 212 Ace without connecting to a PC.
• Delete a single voice message:
Play the voice message you would like to delete. While the message is playing, hold
down the "Mode" button and briefly press "Play". The message will be erased once you
let go of the buttons. You may also delete the message after the playback has stopped.
• Delete all voice messages in one direction:
Pause playback and then press the three buttons „Mode", „Play" and „Right arrow" for at
least two seconds, to delete all following voice messages, including the currently active
one. To erase all previous voice messages and the one currently active, press „Mode",
„Play" and „Left arrow" at the same time for at least two seconds. At the start of the
deleting process you will hear a long beep, followed by an erasing sound when the
operation is complete.

4.5. The 5 recording folders

There are 5 different folders on the internal memory of your Milestone 212 Ace to save
your recorded voice messages in. The default location for recordings is the folder "M1".

4.5.1. Changing between the folders

To switch between available folders, hold "Selector" and press one of the 5 front buttons.
Once you release the buttons, the according folder will be selected. Each of the five front
buttons represents one of the folders. For example, folder „M5" is activated by pressing
„Selector" and „Mode", whereas „Selector" and „Right arrow" corresponds to folder „M4".

4.5.2. Voice labeling of folders

You can create your own custom voice label for each available folder. Keep the „Rec"
button pressed and wait for a clicking sound. Then hold down the „Mode" button too, until
you hear the announcement „folder". Recording starts immediately afterwards, so at this
point you'll want to speak the intended name of the folder into the microphone. Recording
ends with a „high pitched-low pitched" sound sequence, once you let go of the button
combination. Next time you select the folder, it will be announced by your own voice
message. You can repeat the process if required, but please note that if recordings end up
being too short, they won't be registered.
Hint: You can delete recorded folder names directly on your Milestone 212 Ace, but you
will have to activate the folder first. This is done by repeating the above process and
assigning a new recorded name to the folder. Afterwards you'll be able to delete the folder
by pressing the button combination „Mode" and „Play".
11
/17