JVC TK-C1460B Instructions Manual page 33

Item
For setting the signal input or output of the AUX terminal.
AUX
TERMINAL
MOTION:
B&W OUT: A signal is output when the camera switches
B&W IN:
• In setting B&W OUT, if you use an infrared illuminator in
• If the B&W item is set to AUX, the AUX TERMINAL item
This function sets the maximum zoom ratio of the
D.ZOOM
electronic zooming.
MAX
[Set values: x1, x2, x4, x6, x8, x10]
• The electronic zoom function can only be used by the
• Note Picture quality deteriorates under electronic
• When the electronic zoom magnification ratio is
Functions and set values
A signal is output if there is a change in the
area set on the MOTION DETECT screen.
to B&W or Colour mode.
Set to this position when inputting the B&W/
Colour switching control signal to the AUX
terminal. (
MEMO
link motion, hunting can occur. To prevent this, we
recommend that you link in motion this unit and the
infrared illuminator, etc., by control signals after setting
to B&W IN.
changes to [B&W IN] and can not be changed.
MEMO
communication command of exclusive controllers (RM-
P2580, etc.).
zooming as it is accompanied by digital image
processing.
increased, there may be blurring in the upper center left
of the screen. This is a characteristic of the main unit
and is not a malfunction.
Page 11, 30.)
Initial value
(B&W IN)
x2
E-33