Sennheiser ew 500 Instruction Manual page 78

BARS
Ltd
78
Selecting the function of the bargraph displays (EM 500 only)
Generally, the EM 500's two bargraph displays are programmed such that
the upper bargraph indicates the RF level, while the AF level is indicated by
the lower bar. You can, however, program the bargraph displays so that they
indicate the RF levels of the two receiver sections.
Select the "BARS" menu by pressing the
appears on the display; after a short pause the current setting is
displayed.
With the buttons you can now change the function of the bargraph
/
displays:
: RF level of both receiver sections –
"RF I/II" appears on the alphanumeric main display
: RF and AF level –
"RF/AF" appears on the alphanumeric main display
Press the SET button to return to the top menu level.
If the bargraphs indicate the RF levels of the two receiver sections,
the displays RF, I and II on the left of the bargraphs light up.
If the bargraphs indicate the RF and AF level, the displays RF and AF
on the left of the bargraphs light up.
The display then switches back to the standard display.
Limiting the volume at the headphone output (EK 500 only)
In the "Ltd" menu, you can choose the standard volume at the EK 500's
headphone output. With the limiter switched on, the maximum volume at
the headphone output will be reduced by approx. 15 dB.
Select the "Ltd" menu by pressing the
on the display; after a short pause the current setting is displayed.
Press the button to switch the limiter on – if you press the
the limiter is switched off. The new setting – i.e. "Ltd on" or "Ltd OFF"
– starts flashing on the display.
Press the SET button to return to the top menu level. The display
then switches back to the standard display.
Note:
The limiter setting has no effect on the LINE output.
SET button until "BARS"
button until "Ltd" appears
SET
button,