Sennheiser ew 500 Instruction Manual page 65

Inserting and changing the battery
Slide the cover of the battery compartment
arrow until it clicks audibly and open the cover.
Insert the 9 V PP3 battery (IEC 6 LR 61). Please observe correct polarity
when inserting the battery.
Close the battery compartment.
Plugging the transmitter onto the microphone
Plug the transmitter's XLR-3 connector
XLR-3 socket.
Tighten the locking ring
Note:
The transmitter uses the microphone body as an antenna – therefore
only microphones with a metal casing should be used for best signal
transmission.
Switching the transmitter on/off
Press the ON/OFF button
LED lights up.
For phantom powered condenser microphones:
on the phantom powering (P 48) (u "6 Operation").
For dynamic microphones:
powering (P 48) (u "6 Operation"). With the phantom powering
switched on, the operating time of the battery will be reduced to
approx. 5 hours.
To switch the transmitter off, press the
appears on the display. You can then release the button. The red LED
goes off.
Note:
Switch the plug-on transmitter off before changing the microphone.
Muting the transmitter
Use the MUTE switch to noiselessly mute the transmitter's audio signal
(this switch does not switch off the transmitter).
in the direction of the
onto the microphone's
.
to switch the transmitter on. The red
Via the menu, switch
Via the menu, switch off the phantom
ON/OFF button until "OFF"
65