Table of Contents
Advertisement
ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrench
wire cutters
. For help identifying the assembly hardware, see the hardware drawings below.
3/4" Tek Screw (44)–4
Extension Screw
(87)–4
1. With the help of a second person, carefully raise the
Upright Base (85) and the Frame (55) to the position
shown.
While the other person holds the Frame (55) and the
Upright Base (85), insert the Base Extension (90) into
the two brackets on the lower end of the Upright Base.
Make sure that the Base Extension is turned so the
Base Pads (81) are beneath it. Note: It may be helpful
to tip the Upright Base forward as you insert the Base
Extension.
and your own phillips screwdriver
1" Tek Screw (82)–2
3/4" Screw (7)–2
Console Bolt (72)–2
6
Short Console
Star Washer (67)–8
Bolt (112)–2
Pulse Bar Bolt (66)–4
1
55
Brackets
90
81
and
85
81
Hide quick links:
Advertisement
Table of Contents
