Table of Contents
Advertisement
Clarity Visual Systems
On-Screen Menus and Messages
Source Select
Frequency
Phase
Input Level
Position
Zoom
Wall Processor
Color Balance
Curtain
Hours
Save Config
Recall Config
Reset Config
Misc Control
About
Menu Selection
Source Select
Frequency
Phase
Input Level
Position
Zoom
Wall Processor
Color Balance
Curtain
Hours
February 03
82
Selects the type of input source, SVGA , MAC or RGBS, composite
video or S-video
Sets the display's video clock frequency to match the source. Sets the
displayed number of pixels per line of video.
Used to synchronize the WN-5230A-S internal system clock to the clock
phase of the incoming signal.
Displays the Input Level menu, where a black and a white image from
the source are used to calibrate the display to the source. It sets the
minimum and maximum video voltage level that the source is capable
of sending to the display.
Note – The Black Level must be set before the White Level is
calibrated!
Adjusts the horizontal and vertical position of the displayed image.
Changes the image size at all four sides, changing one side at a time,
or both opposite sides together.
If Big Picture option is installed, this opens a menu to turn Wall Mode on
or off. Also set the horizontal and vertical size of the wall and force
display to calculate its position.
Displays the Color Balance menu, to allow color and luminance
matching among multiple WN-5230A-S's.
Displays a black screen instead of the source video.
Displays the Lamp Hours and System Hours menu.
The main menu can be accessed
by pressing the MENU button.
Each sub-menu can be selected by
scrolling to it with the Up/Down
arrow keys and pressing the
ENTER button.
Description
Advertisement
Table of Contents
