Reset Lamp Hours - Clarity Tigress S WN-5230A-S User Manual

Clarity Visual Systems

Reset Lamp Hours

After you change the lamp, use this menu to reset the lamp hour timer
to zero. Lamp hours count up whenever the VideoWall is running (FAN
and LAMP LEDs are on). The system hour timer displays the total hours
that power has been applied to the VideoWall with the power supply
switch on. The system hour timer cannot be reset.
1. Press the MAIN MENU
button on the remote
2. Press the up/down
arrow keys
3. Press ENTER
4. Press left/right arrow
keys
5. Press ENTER
6. Press left/right arrow
keys
7. Press ENTER
February 03
60
Source Select
Frequency
Phase
Input Level
Position
Zoom
Wall Processor
Color Balance
Curtain
Hours
Save Config
Recall Config
Reset Config
Misc Control
About
The Main menu is displayed.
Move the cursor to the Hours selection.
The Lamp Hours menu displays the current number of
lamp operating hours. Replace the lamp at 8,000 hours.
This menu also shows total system hours.
Use the left or right arrow keys to highlight the Yes
selection.
Press the ENTER button to proceed in resetting the lamp
hours to zero.
At this point a warning will prompt 'Did You Replace The
Lamp?' If the lamp was replaced, use the left or right
arrow keys to highlight the Yes selection.
Press the ENTER button to proceed in resetting the lamp
hours to zero.
Lamp Hours: 5987:34
System Hours: 10886:29
Reset Lamp Hours?
[ ] Yes [X] No