Table of Contents
Advertisement
3.6 PTZ Setup
*Note: To control the PTZ, You must connect the wires to the RS-485 port on the back of the DVR
Channel: Choose which camera view you want to work with.
•
Protocol: Choose the "protocol" required for your device. Both protocols require an
•
additional RS-485 data cable.
Device ID: Assign an ID number to each channel (camera view).
•
Baud rate: We suggest using a "baud rate" no higher than 9600 to avoid errors. Please refer to
•
your cameras specifications for the baud rate that is best for your device.
Tour position list: This is where you set up each camera "tour". First, highlight the line in which
•
you want to add your preset, then click the box with the question mark. Use this box to position
the camera to the desired view, then click store. You then need to assign how you want each
position to hold by selecting "keep time". If you change a preset, simply click "update" after you
are done reconfiguring. To delete a preset, highlight the tour you want to delete and click
"remove".
Copy To: User can copy settings to one or all cameras
•
13
Advertisement
Table of Contents
