User Setup - Sony NSP-1 Operating Instructions Manual

Enter the following parameters:
IP Address: Enter the IP address for this unit.
Subnet Mask: Enter the subnet mask of the network
where the unit is to be used.
Default Gateway: Enter the IP address of the default
gateway.
3
Make settings related to the DNS server.
When a DNS server is not used:
Select "No" from "DNS Sever".
When a DNS server is used:
Select "Yes" from "DNS Sever".
Enter the IP address of the DNS server set for the
network (Internet/intranet) to which this unit is
connected.
For detailed information on the address, ask your
network administrator.
4
Make settings related to the proxy server.
When a proxy server is used:
Select "Yes" from "Proxy Server".
Enter the address and the port number in the "Address"
text box and "Port" text box respectively.
Enter the address to be accessed without using a proxy
divides with a "," (comma) in the "Address for Proxy
Server Bypassing" text box.
Ask the network administrator for the address and the
port number.
When a proxy server is not used:
Select "No" from "Proxy Server".
5
Make settings related to the NTP server.
Select whether or not the built-in clock is to be
adjusted via the network.
When an NTP server is not used
Select "No" from "NTP Server".
When a NTP server is used:
Select "Yes" from "NTP Server".
Enter the IP address of the NTP server to be used.
Note
When "Yes" is selected indicating a NTP server is to
be used, the system date and time are set according to
the time information sent from the NTP server.
6
Make settings for "Display."
You can make the following settings:
Resolution: Set the screen resolution to be used.
Orientation: You can select one from among
"Landscape", "Portrait (Counter Clockwise)" or
"Portrait (Clockwise)" based on the orientation of the
plasma display.
Notes
• When "Portrait (Counter Clockwise)" or "Portrait
(Clockwise)" is selected, the resolution and layout of
the material are restricted.
• The VIDEO OUT connector located on the rear
panel of the unit is activated only when "Composite"
is selected from "Resolution," and "Landscape" is
selected from "Orientation." The images output
from this connector will not be displayed correctly
except with the settings described above.
• When "Composite" is selected from "Resolution,"
images will not be displayed correctly on a plasma
display or video monitor connected to the
(analog RGB OUT) connector.
7
Select the video input/output signal format.
Select either "NTSC" or "PAL" from "Video".
8
Click the "Send" button.
The settings made on this page are sent to the NSP-1.
To resume the setup operation, go to another page
without carrying out step 9.
9
Click the "Reboot" button.
This unit is turned off and turned on again. Settings
made are then valid.
To verify the information related to this unit
You can verify the software and hardware version of the
unit on the System Settings page.

User Setup

This page allows you to make settings for creating play
logs and for the recovery mode of the hard disk.
Opening the User Settings page
Click the "User Settings" button.
The User Settings page opens.
Making user settings
1
Make settings for the playout log.
You can select whether or not playout logs sent from
this unit are saved.
To save playout logs: Select "Yes" from "Playout
Log".
To discard playout logs: Select "No" from "Playout
Log".
11
Setup