Product Specific Problems - Dell E1910H User Manual

Wrong Color
Image retention from a static
image left on the monitor for a
long period of time

Product Specific Problems

Specific Symptoms
Screen image is too small
Cannot adjust the monitor with
the buttons on the front panel
No Input Signal when user
controls are pressed
The picture does not fill the
entire screen.
Back to Contents Page
Downloaded from ManualMonitor.com Manuals
Picture color not good Change the Color Setting Mode in the Color Settings OSD to Graphics or Video
l
depending on the application.
Try different Color Preset Settings in Color Settings OSD. Adjust R/G/B value in Color
l
Settings OSD if the Color Management is turned off.
Change the Input Color Format to PC RGB or YPbPr in the Advance Setting OSD.
l
Run the built-in diagnostics.
l
Faint shadow from the static Use the Power Management feature to turn off the monitor at all times when not in use
l
image displayed appears on (for more information, see
the screen Alternatively, use a dynamically changing screensaver.
l
In OSD Menu, under Reset to Factory Settings, select Enable LCD Conditioning. Using
l
this option may take several hours before the image is eliminated.
NOTE: Image Burn-in is not covered by your warranty.
l
What You Experience
Image is centered on screen, Reset the monitor to Factory Settings.
l
but does not fill entire viewing
area
OSD does not appear on the Turn off the monitor, unplug the power cord, plug back, and then turn on the monitor.
l
screen
No picture, the LED light is Check the signal source. Ensure the Computer is not in the power saving mode by
l
moving the mouse or pressing any key on the keyboard.
blue. When press "up", "down"
Check whether the signal cable is plugged in properly. Re-plug the signal cable if
or "Menu" key, the message "
l
No input signal " will appear. necessary.
Reset the computer or video player.
l
The picture cannot fill the Due to different video formats (aspect ratio) of DVDs, the monitor may display in full
l
height or width of the screen screen.
Run the built-in diagnostics.
l
Power Management Modes).
Possible Solutions