Sony BVM-X300 Operating Instructions Manual page 22

Submenu Setting








[Transfer Matrix] Select the transfer matrix from the
following:


[SDI 2K Input]
Setting
Set the input connector of the SDI 2K signals.
[Input1]: Select to input to Input 1 with Single Link.

[Input2]: Select to input to Input 2 with Single Link.

[Input3]: Select to input to Input 3 with Single Link.

[Input4]: Select to input to Input 4 with Single Link.

[Input1&2]: Select to use Input 1&2 with Dual Link.

[Input3&4]: Select to use Input 3&4 with Dual Link.

22
Adjustment Using the Menus
In the HDR display, the cooling fan
is forcibly rotated regardless of
outside temperature.
In the HDR display, the screen saver
is forcibly set. [Off] cannot be
selected.
In the HDR display, [Flicker Free]
cannot be selected. [On] is always set
for signals of vertical frequency 24
Hz, 25 Hz, 48 Hz, and 50 Hz. [Off] is
always set for signals of 30 Hz and 60
Hz.
The protective function for the
OLED panel activates and inserts the
black level in one field according to
the input signal.
When the signal to display high
brightness images on the larger part
of the screen is input, blinking may
occur due to the protection function.
This is not a malfunction. There is
no effect on the throughout.
Using the unit with the high
brightness display for extended
periods may cause eyestrain or
reduction of eyesight. Be sure to take
an occasional break when using.
Follow RECOMMENDATION ITU-
R BT.1702 "Guidance for the
reduction of photosensitive epileptic
seizures caused by television" or
other guidelines to use.
In the HDR display, the display
surface may emit heat when high
brightness images are output. Do not
touch the surface.
Do not display static images that
contains high brightness display,
time codes, markers, or logos for
extended periods to reduce the risk
of burn-in. Consider to apply a
displaying method with a low level
signals of 100% or less.
[ITU-R BT.709]
[ITU-R BT.2020]
[2K/HD Input Setting]
Submenu Setting
[Interface Format] Displays the interface format of the 2K
input.
[Single-Link 3G/HD-SDI]: For

[Dual-Link 3G-SDI]: For Dual Link

[Signal Format] Select from the following when
[Interface Format] is [Single-Link 3G/
HD-SDI].
[Auto]

[422 YCbCr 10bit]

[444 RGB 10bit]

[444 YCbCr 10bit]

[444 RGB 12bit]

[444 YCbCr 12bit]

Select from the following when
[Interface Format] is [Dual-Link 3G-
SDI].
[Auto]

[444 RGB 10bit]

[444 YCbCr 10bit]

[444 RGB 12bit]

[444 YCbCr 12bit]

[RGB Range] Select from the following when [Signal
Format] is set to RGB.
[Full]

[Limited]

[Color Space] Select the color space from the
following:
[ITU-R BT.709]

[EBU]

[SMPTE-C]

[Native]

[S-Gamut/S-Gamut3]

[S-Gamut3.Cine]

[DCI-P3]

[ITU-R BT.2020]

[EOTF] Select the gamma from the following:
[2.2]

[2.4]

[2.6]

[CRT]

[2.4(HDR)]

[S-Log3(HDR)]

[S-Log2(HDR)]

Single Link.
of 3G-SDI.