Sony BVM-X300 Operating Instructions Manual page 21

Submenu Setting
[Screen Saver] Sets the screen saver function [On] or
[Off].
[On]: If a still image is displayed for

[Off]: The screen saver function is

Note
In the HDR display mode, this setting is
forcibly set to [On].
For details on the HDR (High Dynamic
Range) display, see page 21.
[Power On Setting] Sets this unit's setting status after the
unit is turned on. Select from [Last
Memory], [User Preset1], [User
Preset2], [User Preset3], [User Preset4]
or [User Preset5].
[User Reset] Returns to the factory default setting
except for the following:
Color temperature for [User1]

Color temperature for [User2]

Color temperature for [User3]

Color temperature for [User4]

Color temperature for [User5]

User Preset for [User Preset1]

Password setting

[Cancel]: Cancels reset.

[Confirm]: Resets the unit. When

[Input Setting]
more than 10 minutes, the
brightness of the screen is
automatically decreased to
reduce burn-in. The screen
returns to normal brightness
when you input a video signal to
the unit or operate the buttons
on the front panel of the unit.
While the screen saver is active,
the STATUS indicator flashes
every two seconds. Before the
screen saver starts up, the
STATUS indicator flashes every
second to notify users that the
screen saver will start up.
deactivated.
reset finishes, this unit restarts.
[4K/UHD Input Setting]
Submenu Setting
[Interface Format] Displays the interface format of the 4K
input.
[Quad-Link 3G/HD-SDI]

[Image Division] Set the image division of the 4K input.
[Auto]: Select for the Auto setting.

[2SI]: Select to receive images of the 2

[Square]: Select to receive images of

[Signal Format] Select a signal format from the
following.
[Auto]

[422 YCbCr 10bit]

[444 RGB 10bit]

[444 YCbCr 10bit]

[444 RGB 12bit]

[444 YCbCr 12bit]

[RGB Range] Select from the following when [Signal
Format] is set to RGB.
[Full]

[Limited]

[Color Space] Select the color space from the
following:
[ITU-R BT.709]

[EBU]

[SMPTE-C]

[Native]

[S-Gamut/S-Gamut3]

[S-Gamut3.Cine]

[DCI-P3]

[ITU-R BT.2020]

[EOTF] Select the gamma from the following:
[2.2]

[2.4]

[2.6]

[CRT]

[2.4(HDR)]

[S-Log3(HDR)]

[S-Log2(HDR)]

Note
When [2.4(HDR)], [S-Log3(HDR)], or
[S-Log2(HDR)] is selected, HDR (High
Dynamic Range) is displayed.
The HDR display is a method to
faithfully display the brightness of
signals defined of 100% or more level
without compressing the brightness
parts.
sample Interleave system.
the Square system.
Adjustment Using the Menus
21