Table of Contents
Advertisement
Available languages
Available languages
EN
WARNING
The belt system is adjusted correctly when the belts lay firmly
on the childs body.
4.3 Height adjustment of the shoulder belts
Push the plastic clip on the backside of the backrest through the hole to the front
(fig. 15; no. 1).
Do the same on the second side.
Now insert the plastic clip into the hole at the required height (fig. 15; no. 2).
WARNING
The plastic clip must lay flat on the backside of the backrest.
WARNING
Make sure that both shoulder belts are fixed at the same
height.
4.4 Opening / closing the bumper bar
To open the bumper bar, press the release button (fig. 26; no. 1) and open the bumper
bar (fig. 26; no. 2).
To close the bumper bar, push the releasing button into the guide on the chassis.
WARNING
Make sure that the bumper bar is always closed correctly when
seat unit is in use. Never use the seat unit without the bumper bar.
27
5. Using with an infant carrier
5.1 Mounting the travel system adaptors on the chassis
WARNING
Unfold the stroller as described in section 3.1 and set the
parking brake.
Slide the adaptor from inside on the metal profile above the seat (fig. 16; no. 1).
Position the travelsystem adaptor between the two position locators at the lower side
of the tube (fig. 16; no. 2).
Now fix the travelsytem adapter by closing the flap (fig. 17).
Do the same on the opposite side.
WARNING
Ensure both locking devices are engaged before use!
5.2 Mounting the infant carrier adaptors
Insert both adaptors into the channels on the travelsystem adaptors (fig. 18).
WARNING
Ensure both locking devices are engaged before use!
5.3 Mounting and removing a Kiddy infant carrier
WARNING
Make sure that your child is secured in the infant carrier as
described in the operating manual.
Attach the infant carrier rearward facing to the adaptors (fig. 19). Push and hold both
buttons on either side of the infant carrier handle (fig. 20; no. 1).
EN
28
Advertisement
Chapters
Table of Contents
