Makita FS2500 Technical Information page 3

R
epair
[3] DISASSEMBLY/ ASSEMBLY
[3]-1. Clutch portion (cont.)
ASSEMBLING
1) Face the cylindrical end of Collared pin 8 to the cam portion of Spur gear 35-180, and press-fit Collared pin 8 into
Spur gear 35-180 until it stops by the stopper as illustrated in Figs. 5 and 1.
2) Take the disassembling step in reverse to assemble the remaining parts to Collared pin 8 with Spur gear 35-180.
Note: Compression spring 6 has to be set between the bottom of Spindle hole and one end of Collared pin 8. Refer to
Figs. 4 and 1 and pay attention to the direction of Collared pin 8.
3) Regarding Gear complete 17-39;
Pressfit Ball bearing 606ZZ and mount Flat washer 8 as illustrated in Fig. 6, then set the assembled part in place.
Fig. 5
Flat area
Stopper
cylindrical end
Spur gear 35-180
Flat portion
[3]-2. Assembling of Ring spring 33 and Leaf spring
1) Face the ends of Ring spring 33 to the left side when holding the machine as illustrated in Fig. 7, and fit Ring spring 33
into the groove on Gear housing complete.
2) Face the ends of Leaf spring to the right side when holding the machine as illustrated in Fig. 8, and hook the carved
ends of Leaf spring with the ribs of Gear housing complete.
Fig. 7
Ends of
Ring spring
33
Viewed from left side
Collared pin 8
Cam portion
Fig. 8
Groove on
Gear housing
complete
Viewed from right side
Fig. 6
Ball bearing Flat washer 8
606ZZ
Gear complete
17-39
Protrusions of Gear housing complete
Carved end of
Leaf spring
Ribs of Gear housing complete
to hook Leaf spring
P 3/ 6